Standing Seam Metal Roof Slope Transition

Minimum slope requirements depending on the roof profile there are minimum roof slope requirements for each panel which need to be considered.

Standing seam metal roof slope transition. This means that the minimum roof slope required for panels is 3 inches of rise per foot. Low slope metal roofs have simple geometries and are easier and less expensive to install that medium to steep slope roofs. Low slope metal roofs require less material which reduces the overall load on the building s structure. You ll have a steeper part of your roof turning into a lower slope so there s a steeper pitch up top and a lower pitch on the bottom.

Roof pitch slope for reference standing seam metal roofing is not one size fits all. This guide is does not cover some aspects of installation. Butyl sealant tape or tube sealant should be used under all z channel. We require at least a 3 12 pitch for standing seam panels to ensure proper water drainage.

By the way pitch is measured by picking any point on the roof place a level on it measure 12 out from that point this is called the run and then down to the roof surface from the bottom of the level this is called the rise to see how many inches the roof pitches over 12. We re going to do a pitch transition or change. We need to do something where that change happens so the panels can go down and water can come off hit the lower slope and come off the roof. The minimum slope for standing seam of roof systems shall be one quarter unit vertical in 12 units horizontal 2 percent slope.

See our installation guide for more info. As you can see from illustration the roof changes pitch at the porch from a 9 12 to a 3 12 pitch.