Tacks Sticking Up Through Carpet

Op can do this and the problem will go away.

Tacks sticking up through carpet. When the tack strips are nailed screwed or glued to the subfloor with the tacks angled toward the wall the tacks will grip the carpet backing and hold the carpet in place as it is installed. Fasten the pad to a concrete floor with carpet pad adhesive and duct tape the seams together photo 2. Beating the tack strip pins down through the carpet will usually work the risk being it may dimple the carpet slightly. After the carpet was stretched the installer should have hammered down the pins on the tack strip.

Don willott owner of don s floor coverings mentions that the typical. Once the carpet is stretched onto the pins they must be tapped over in a doorway tile junction to reduce the problem of feeling the tacks through the carpet. Obviously the thickness of the carpet has a bearing on whether the tacks will be a problem in a walk area. What is a carpet tack strip.

Carpet tack strips are lengths of wood usually douglas fir about four feet long and one inch wide. Use a utility knife to trim off any pad covering the tack strip. We have z bar metals that the carpet wraps around or it can just be tucked between the tack strip and tile if there is enough height difference as is the case for op. Once the carpet is rolled out and installed it has to be tacked down.

Tacks sticking up through the carpet we have advised management several times since the remodel what a poor job that tacks stick up through the cheap indoor outdoor carpet in 16e section ii. The tacks will grip the backing and hold the carpet in place. On a wood subfloor all you need is a staple gun and 5 16 in.