Tarkett Flooring Installation Instructions

Room temperature must be maintained between 65 ｰ workmanship is employed in the and 85 ｰf 18 ｰ and 30 ｰc with hvac system operating.

Tarkett flooring installation instructions. Those temperatures could be different. If the heating pipes are too close to the flooring the flooring may discolor next to the pipe work. Pvc or. The end joints of the planks in the first row.

These instructions combined with our adhesives and flooring products create a system. Tarkett will not accept responsibility for claims on flooring installed with obvious defects. Ensure the subfloor is dry clean and flat. During installation inspect the groove area and remove any debris that may prevent proper assembly of planks.

Saw pencil tape measure vacuum cleaner step 1 prepare your subfloor to ensure a smooth installation it is important to prepare the surface. Heating pipes shall be at least 2 inches 50 8mm below the surface of the concrete. Subtract 1 4 6 3mm or 1 2 12 7mm depending on the size of the spacer used from this measurement to allow for the spacer. Install transition reduction profiles where needed.

Do not use a hammer and tapping block to install planks. For installation room temperature should always be above 15 c or 18 c for linoleum. However there are a few exceptions. In most cases you need to remove the existing floor covering.

Tarkett laminate8 installation instructions 2 locktarkett laminate9 installation instructions 2 lock finish remove the spacers from the perimeter of the room. Vinyl composition tile flooring. To get started you need to do the following. Installation begin laying planks from the left side of the starting wall and work to the right side.

Rolls and tiles must be stored during 48 hours before starting the operation. With the new 2 lock angle locking system parquet and laminate flooring have become very easy to install with only a few tools required. Do not install damaged planks. Tarkett flooring and adhesives must be site conditioned at room temperature for a minimum of 48 hours prior to during and after installation.

The tongue side of the plank. Before installation sheets and tiles should relax minimum 24h out of packaging. Rubber tile flooring installation instructions introduction these instructions are written as a guide to be used by professional installers when installing tarkett products. Measure distance between wall and surface of full plank.

If this measurement is less than 12 20 3cm the length of first plank in the row must be cut. Place 1 4 6 3mm spacers between the short and long side of the planks and the wall use 1 2 12 7mm spacers for. Check the rules in your country. Remove your vinyl floor from its packaging and keep it in the room where it is to be.