Tear Up Old Carpet

Start at one corner of your room and try to pull up the carpet.

Tear up old carpet. To tear up your old carpet pull the carpet free from the tack strip connected it to the wall with pliers. Detach carpet from tack strip and adjacent surfaces. How to remove old carpet 1. Level the sub floor and replace any water damaged wood as needed.

After you ve rolled up the old carpeting and removed it from the room you ll finally get a good look at the subfloor and any surprise damage that the carpet may have been hiding. Tack strips are metal nails that line the perimeter of your walls to hold the carpet. Remove worn carpet pad and tack strips. Detach carpet from tack strips.

Remove all debris from home and dispose of legally. Includes planning equipment and material acquisition area preparation and protection setup and cleanup. Just grab the carpet with pliers and pull. Go to a corner of your carpeting and run a standard screwdriver between the edge of the wall and carpet.

Touch up paint on baseboards and around the. Once the carpet is free pull the carpet up by hand. Then grab the carpet by hand and continue to pull it up along an entire wall. If it won t come up then cut a small 6 inch by 6 inch square in the corner with your utility knife.

Use pliers to tightly grab the carpet. Pull up a few feet of carpet and fold it over. How do you remove carpet glue. Remove this small piece of carpet and then pull upon the larger section.

Your carpet is held down with tack strips. When the corner of the carpet is loose use your gloved hands to pull along the length of the wall. Pull toward you to detach it from the sharp tack strip that holds it to the floor along the wall. Prep before pulling up carpet.

Fold the carpet over for easy cutting and slice it into narrow strips. Remember to cut the carpet into smaller pieces as you go to make it easier to move and dispose of. Remove the carpet tacking strips which may be nailed or stapled to the hardwood floor. Use a utility.

Cut carpet into haul able pieces. To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner. Apply a stain blocking primer to prevent old stains from coming up through new carpet. Roll up the strips and tape them for easy handling.

Drive long wood screws into the sub floor and through to floor joists anywhere the floor squeaks.